Eurocave INOA 25 Operations Instructions download pdf (Page 20)

7 - COMMISSIONING YOUR CONDITIONER

IV- Installing the remote control

You can install the remote control inside your cellar.

We recommend that you place it as close as possible to the bottles.

Fix the unit close to your bottles using the supplied pegs and screws (see diagram below)

N.B.: Do not place the remote control in the path of the conditioner’s cold air flow.

Installing the remote control outside the cellar

It is also possible to place the remote control outside the cellar.

In this case, it is essential to connect a sensor (supplied with the appliance) to the remote control before installing it.

a- Connecting the sensor to the remote control

- On the back of the remote control, push the 2 batteries downwards using a screwdriver (diagram 1).

- Remove the central knob, unscrew the screw with a small screwdriver and open the unit (diagram 2)

- On the back, connect the sensor’s 2 wires (blue and red) to the circuit connector using a small flat screwdriver (diagram 3).

You can connect either the blue wire or the red wire to the circuit connector.

Pass the wires through the recess on the top of the unit.

- Close the unit, ensuring that the wires pass through the recess and are not jammed

- Rescrew and replace the central knob

- Replace the batteries. One in use and the other as a spare with plastic insulator

b- Programming the remote control

Where placing the remote control outside the cellar, having connected the external sensor, it is essential to reprogramme the unit

- To turn on the remote control, press and hold down the key for about 8 seconds until the indicator goes off.

- First press and continuously hold down the key, at the same time press and continuously hold down the key for several seconds until three lines

appear. The model number is then displayed and flashes. .

- Press .

- The screen appears indicating IN (IN= internal installation). Press the key to change to OUT external mode.

- The display appears indicating OUT (OUT= external installation). Press to confirm.

- The pictogram appears. Press .

- The screen appears. Press .

- The pictogram appears. Press .

- .appears. Press .

- The pictogram appears. Press .

- The screen appears, then .

1 2 3

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

No comments

Eurocave INOA 25 Operations Instructions Page 20